Recommended Tools Review
After watching the video, click the mark complete button below and then take the Recommended Tools Quiz.
Section Summary
Building with BuildBlock ICFs requires surprisingly few tools, and most of what you need is already on a typical jobsite. This lesson covers the essentials, along with a few optional tools that save time and labor.
Start with the basics: a hammer, drill, and tape measure handle most tasks throughout the build. To keep walls level and openings square, keep a standard or laser level and a framing square on hand, plus a chalk line or mason’s line to mark the outside edge of the block on the footing.
Cutting is constant. Blocks are trimmed to create a running bond and eliminate vertical seams where possible, and to frame door and window openings. The EPS foam cuts easily, and the block’s one-inch repeating interlock pattern keeps waste low. Cut lines and measurements are molded right into the block. A folding pruning saw, short shark saw, keyhole saw, circular saw, or even a table saw all work; a hot knife produces the cleanest cuts with the least waste. The same tools open penetrations for plumbing and mechanical sleeves and, after the pour, create electrical and plumbing chases.
For reinforcement, you’ll need a rebar cutter and bender to prep horizontal steel, plus a rebar tie tool to connect vertical and horizontal bars where required—tying vertical steel is usually recommended on the top course. Before pouring, walls must be aligned and braced. The BuildBrace Bracing and Alignment System is popular with contractors; its Strongback aligns with BuildBlock’s patented hard attachment points for the strongest connections. The Zont and Zuckle system by Fab-Form is a common alternative for DIY installations or when bracing rental isn’t available, combining standard lumber with a turnbuckle to align the walls. You’ll also need scaffold planks or walk boards for the crew—typically the same material used for the top plate.
As concrete is poured, it must be consolidated with a concrete pencil vibrator; internal vibration is required to remove trapped air and produce a structurally sound wall. Keep a concrete trowel for finishing and a foam gun to fill cracks or voids.
Optional time-savers include the Benner Nawman Cutting Edge Saw, which cuts rebar inside the cavity without sparking; permanent markers for marking cuts, opening centerlines, and rebar locations; and easy-to-forget supplies like gloves, sunscreen, brooms, and floor scrapers that keep the site safe and efficient.