Basic ICF Installation Plumbing, Electrical, and Mechanical Installation Plumbing, Electrical, and Mechanical Installation Quiz

The Plumbing, Electrical, and Mechanical Installation quiz will cover some of the basic material presented in this lesson. Please answer the questions below. After completing the quiz you may mark this lesson complete and continue on to the next lesson.

Note: All quizzes in this course require an 80% passing grade to continue to the next lesson. If you do not meet the required score, click the “View Questions” button to see which questions were answered incorrectly and then click “Restart Quiz” to try again. 

Good luck!

How can you locate BuildBlock webs after concrete is poured but before the wall is finished?
What is the pull out strength of the full face of the web?
What is the pullout strength of the high density attachment points on each BuildBlock web?
What are the dimensions of the BuildBlock webs?
How far are the BuildBlock high density attachment points from the top and bottom of the block?
What is the spacing of high density attachment points once the ICF wall is stacked?
What is the best way to find an attachment point after the wall is covered?
Which cutting tool creates the least waste when cutting chases in the ICF?
When cutting chases:
What extra step should be taken if mounting an electrical panel directly to the ICF wall.
Where is it not recommended to run plumbing?
If plumbing must run inside the wall cavity, extra vibration is required to properly consolidate concrete around the pipe.